Wilson Electronics WILSONPRO PRO 140i Installation Manual page 14

Specifications
Model Number
FCC ID
IC ID
Connectors
Antenna Impedance
Max Gain
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Noise Figure
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter
incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster
is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency
band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that
band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1
minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster
has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster's microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority
to operate this equipment.
12
INDUSTRIAL-CLASS IN-BUILDING, CELL SIGNAL AMPLIFIER
460074
PWO074
4726A-074
N-F emale
50 Ohms
80 dB
758-768 MHz, 788-798 MHz
700 Band 14
MHz
27.0
700 Band 14
MHz
27.0
5 dB nominal
120V AC 0.5A
PRO 140i