Removing/ Installing Castings; Installing The Ceramics - Focal Point EKO 6010 Installation & User's Instructions

7.1 REMOVING/INSTALLING THE CASTINGS
Ensure that the fire is off and cool before attempting to remove or
assemble castings.
The stove is supplied with the castings fitted. To fit the fuel bed it is necessary to
partially dis-assemble the stove as follows;
1) Remove the top grille by the two screws in the top of the appliance, push the
rear of the grille down so the front end of the grille lifts up. DO NOT LEVER
OFF WITH A SCREWDRIVER.
2) Remove the top casting by unscrewing the four screws holding it in place.
3) Unscrew the cross head screw holding the front casting down at the top. The
front casting is now free to be removed.
4) Remove the glass door by unscrewing the four retaining screws in each cor-
ner.
5) Fit the ceramic components as detailed in section 7.2.
6) Re-fit the glass door after cleaning or inspection, ensuring a good seal.
7) Attach the decorative handle to the front casting using the M6 x 15mm screw
supplied.
8) To re-assemble the castings read instructions in reverse order.
9) Attach the control handle into position through the opening in the front
panel.

7.2 INSTALLING THE CERAMICS

Use a flat blade screw driver to carefully lever
the two rear return tabs out to 90° on both left
and right hand sides of the firebox as shown.
Next insert the rear brick panel through the bottom of the firebox as shown, in front of
the returned tabs but behind the bottom lip. Ensure the brick effect is in the correct ori-
entation, with the lip on the top edge.
Install one side brick panel in the left hand side of the firebox, behind the bottom return.
Install the right hand brick panel in the same manner (the brick effect panels are not
labelled). Ensure the brick effect is in the correct orientation, with the lip on the top edge,
so the brick effect is continuous around the firebox.
Figure 9
6
Figure 8
Figure 10
Figure 11
Figure 12
GB IE
© 2016 Focal Point Fires plc.