Installing The Ceramics - Focal Point LEIRVIK Installation And User Instructions Manual

7.1 REMOVING/INSTALLING THE CASTINGS
Ensure that the fire is off and cool before attempting to remove or
assemble castings.
The stove is supplied with the castings fitted. To fit the fuel bed it is necessary to
partially dis-assemble the stove as follows;
1) Remove the top grille by the two screws in the top of the appliance, push the
rear of the grille down so the front end of the grille lifts up. DO NOT LEVER
OFF WITH A SCREWDRIVER.
2) Remove the top casting by unscrewing the four screws holding it in place.
3) Unscrew the cross head screw holding the front casting down at the top. The
front casting is now free to be removed.
4) Remove the glass door by unscrewing the four retaining screws in each cor-
ner.
5) Remove the burner assembly which is fitted with one screw either side.
6) Fit the ceramic components as detailed in section 7.2.
7) Re-fit the burner and the glass door after cleaning or inspection, ensuring a
good seal.
8) Attach the decorative handle to the front casting using the M6 x 15mm screw
supplied.
9) To re-assemble the castings read instructions in reverse order.
10) Attach the control handle to the burner assembly through the opening in the front panel.

7.2 INSTALLING THE CERAMICS

Use a flat blade screw driver to carefully lever
the two rear return tabs out to 90° on both left
and right hand sides of the firebox as shown.
These tabs can also be identified as they do not
feature a dot on, like the other tabs.
Lay the firebox onto it's back on a soft surface so you are able to slot the rear brick panel
through the bottom of the firebox as shown, in front of the returned tabs but behind the
bottom lip. Ensure the brick effect is in the correct orientation, with the lip on the top
edge.
Install one side brick panel in the left hand side of the firebox, behind the bottom return.
Install the right hand brick panel in the same manner (the brick effect panels are not
labelled). Ensure the brick effect is in the correct orientation, with the lip on the top edge,
so the brick effect is continuous around the firebox.
A
Figure 9
6
Figure 8
Figure 10
Figure 11
Figure 12
GB IE
© 2014 Focal Point Fires plc.
F