Table of Contents
Advertisement
7.2 INSTALLING THE CERAMICS -
Finally screw the "L" ceramic clamps into position in both side of the firebox with the self
tapping screws provided.
1. Remove the ceramic components from their protective packaging. Place the log marked
'A' on the top left rear ledge behind the burner mixer chamber as shown in figure 14.
2. Place the log marked 'B' on the top right rear of the burner as shown in figure 15.
Ensure that both rear logs are pushed back against the rear brick panel.
3. Place the log marked 'C' on the front ledge of the burner, behind the return and in front
of the burner mixer chamber.
8.0 TESTING AND COMMISSIONING
Turn on and test the gas supply up to the fire for any leaks, in accordance with the current edition of BS 6891 (natural gas installations)
or the current edition of BS 5482 pt1 (propane installations). For Republic of Ireland, reference should be made to the current edition
of IS813 (the relevant standards governing installation).
8.1 CHECKING THE BURNER AND SPARK GAP
The appliance features a ribbon burner which is designed to produce a continuous band of flame
over its length.
The burner should be visually inspected to ensure it is free from any foreign matter.
If it is necessary to clean or dust off the burner, ensure that the fire is off and cool. To remove
see section 7.1. The gap between the spark electrode and the pilot should be 3.5 - 4.5mm to pro-
duce a good spark (see figure 17). There should be no need to adjust this. If under any circum-
stances the piezo electric spark fails, the pilot cannot be lit manually.
(CONTINUED)
7
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
Spark gap
© 2016 Focal Point Fires plc.
GB IE
Advertisement
Chapters
Table of Contents
