Table of Contents
Advertisement
9.0 CLEANING
Before carrying out any of the following operations, ensure that the appliance is OFF and completely cold. Regularly clean around the
appliance to ensure that dust, fluff, pet hair etc, are kept to a minimum. There are no other specific requirements for care, other than
regular cleaning of the general appliance.
A wipe with a dry cloth is normally sufficient. DO NOT use abrasive cleaners as they can damage the finish. Metal parts may be cleaned
using an appropriate metal cleaner. Test on a hidden part before cleaning. Clean only in the direction of the grain.
GLASS PANEL - This can be cleaned with a suitable glass cleaner. Test on a small area first.
PAINTED AREAS - These can be cleaned using a dry cloth.
CERAMICS - Remove the ceramic components. Gently clean in the open air. Be careful not to create dust from the logs. Where neces-
sary replace damaged components with genuine spares. Seal scrap components in plastic bags and dispose of at proper refuse sites as
directed.
10.0 REPLACING THE BATTERY
Ensure appliance is off and cool. The battery is located in the front of the ignition unit, on the
right hand side of the burner (Shown in figure 13). Unscrew the battery holder cap. Insert 1 x
'AA' (1.5 volt) battery. Replace cap. This can be achieved without removing the castings .
11.0 LIST OF REPLACEMENT PARTS
The Installation instructions carry full servicing details for the use of the installer.
PART NO.
F550436
F550433
F550435
F550339
F730067
F730069
F730106
TBC
F730070
F730104
F510127
F510133
F780079
F740004
ITEM
Ceramic log set
Ceramic brick tiles
Glass tiles
Glass door assembly
Gas valve
Pilot assembly - (Natural Gas SIT 9110)
Pilot assembly - (Natural Gas Copreci 21100 2F/ 296)
Pilot assembly - (LPG - Propane)
Injector - (Natural Gas 1.30)
Injector - (LPG - Propane .83)
Burner unit (Natural Gas)
Burner unit (LPG - Propane)
Catalyst
Ignitor
5
GB IE
Figure 13
© 2016 Focal Point Fires plc.
Advertisement
Chapters
Table of Contents
