Connect The Network Devices - HP 8200 zl Installation And Getting Started Manual

To Power Source
8200 zl
Figure 2-13. Connecting the EPS to two 8200 zl switches
These examples show the switch and the EPS using the J8713A power supply,
the J8712A power supply can also be used. It depends on how much PoE
power is required.
For more information on PoE requirements see the HP Power over Ethernet
(PoE/PoE+) Planning and Implementation Guide.

9. Connect the Network Devices

The type of network connections you will need to use depends on the types
of switch modules you have installed in your 8200 zl switch. See the documen-
tation accompanying the modules for cabling configurations and procedures
for those modules.
In general for all the modules, when a network cable from an active network
device is connected to the switch, the Link LED for the switch port should go
on. If the Link LED does not go on, use the table below to help solve the
problem, and see the module documentation for troubleshooting procedures.
Condition Diagnostic Tip
To Power To Power
Source
Source
EPS Cables
Installing the HP 8200 zl Switches
Installation Procedures
To Power Source
8200 zl
2-25