HP 8200 zl Installation And Getting Started Manual page 49

Installing the HP 8200 zl Switches
Installation Procedures
Figure 2-9. Power Connector on Back of Switch
N o t e
The 8200 zl switches do not have a power on-off switch. It is powered on when
the power cord is connected to the switch and to a power source.
If your installation requires a different power cord than the one supplied with
the switch, please see the "Installation Precautions" on
2.
2-18
Check the LEDs on the switch and on each of the switch modules. The
LED behavior is described on the next page.
If the LED display is different than what is described, especially if the
Fault LED stays on for more than approximately 120 seconds or it starts
blinking, the self test has not completed correctly. Refer to chapter 5,
"Troubleshooting" for diagnostic help.
Connect power cord to
power connector
page 2-6.