Replacing Components
Replacing the Services Module Disk Drive
Replacing the Services Module Disk Drive
The hard disk drive (HDD) is the primary storage medium located on the
Services Module. When a disk drive fails the "HDD status" LED on the Services
Module will blink simultaneously with the switch Fault LED.
Installing a Disk Drive
To install (or replace) a Disk Drive:
1.
2.
3.
4.
5.
4-10
Using either a flat-bladed or Torx T-10 screwdriver loosen the retaining
screws securing the module. (You cannot access the disk drive when the
module is installed.)
Using the extractor handles, pull the module from the slot and turn it over.
Using a Cross Recess Type 1 No.1 (Phillips tip) screwdriver remove the 4
retaining screws holding the disk drive.
Slide the disk drive half way back to disconnect it.
Position the disk drive in the middle of the disk drive slot.