Download Print this page

HP ProCurve 5400zl Installation And Getting Started Manual: Connect The Network Devices

Procurve 5400zl series switches.
Hide thumbs

Advertisement

Installing the 5400zl Switches
Installation Procedures
To Power
Source
5406zl
Figure 2-12. Connecting the EPS to two 5406zl switches
Although these examples show the EPS connecting to the 5406zl switch, it can
also be connected to a 5412zl switch in the same manner. These examples also
show the switch and the EPS using the J8713A power supply, the J8712A
power supply can also be used. It depends on how much PoE power is
required.
For more information on PoE requirements see the PoE (Power over
Ethernet) Devices Planning and Implementation Guide.

9. Connect the Network Devices

The type of network connections you will need to use depends on the types
of switch modules you have installed in your 5400zl switch. See the documen-
tation accompanying the modules for cabling configurations and procedures
for those modules.
In general for all the modules, when a network cable from an active network
device is connected to the switch, the Link LED for the switch port should go
on. If the Link LED does not go on, use the table below to help solve the
problem, and see the module documentation for troubleshooting procedures.
2-22
To Power
Source
EPS Cables
5406zl

Advertisement

Troubleshooting

   Related Manuals for HP ProCurve 5400zl

Comments to this Manuals

Symbols: 0
Latest comments: