Download Print this page

HP 5400 zl Installation And Getting Started Manual: Connect The Network Devices

5400 zl series switches.
Hide thumbs

Advertisement

To Power
Source
5406 zl
Figure 2-14. Connecting the EPS to two 5406 zl switches
Although these examples show the EPS connecting to the 5406 zl switch, it
can also be connected to a 5412 zl switch in the same manner. These examples
also show the switch and the EPS using the J8713A power supply, the J8712A
power supply can also be used. It depends on how much PoE power is
required.
For more information on PoE requirements see the PoE (Power over
Ethernet) Devices Planning and Implementation Guide.

9. Connect the Network Devices

The type of network connections you will need to use depends on the types
of switch modules you have installed in your 5400 zl Switch. See the documen-
tation accompanying the modules for cabling configurations and procedures
for those modules.
In general for all the modules, when a network cable from an active network
device is connected to the switch, the Link LED for the switch port should go
on. If the Link LED does not go on, use the table below to help solve the
problem, and see the module documentation for troubleshooting procedures.
Installing the HP 5400 zl Switches
Installation Procedures
To Power
Source
EPS Cables
5406 zl
2-21

Advertisement

Troubleshooting

COMING SOON

   Related Manuals for HP HP 5400 zl

This manual also for:

5406 zl, 5412 zl

Comments to this Manuals

Symbols: 0
Latest comments: