Operation After Installation; Power On; Input Level Control - Dynacord V Series Installation Manual

V Series
6

Operation after installation

6.1

Power on

The device can be activated by pushing the power button on the front panel. Speaker
system switch‑on is delayed by approximately three seconds via output relays, effectively
suppressing any possible power‑on noise, which otherwise might be heard through the
loudspeakers.
–
6.2

Input level control

Adjustment of amplifier to source.
–
The level control is assigned with the physical input, not the output channels. If routing
PARALLEL or IN1 to ALL is used, the level control is same for all channels.
Notice!
i
The level control of the unused input is ineffective. If however independent level control is
desired, the DUAL routing should be used instead and the inputs wired as parallel.
Refer to
–
Dynacord
See also Remote on, page 36.
Default is middle position. Full clockwise spends additional 6 dB to drive the amplifier
even from weak sound sources.
Indicators, controls and settings, page 25
Installation manual
Operation after installation | en
2024.01 | V03 | F.01U.402.248
37