Dynacord V Series Installation Manual page 16

16 en | General installation procedures
Side-by-side mounting in a 19"-rack
If you intend to use the full 19"-rack, you can stack two V600:2 amplifiers in one rack slot.
To install both amplifiers in a side-by-side configuration:
1.
2.
II
Figure 4.4: Connecting the rack ears and the connecting plate
3.
2024.01 | V03 | F.01U.402.248
Mount the one short rack ear to one side of one amplifier using the existent screws (C).
Unscrew the existent screws, attach the rack ear and screw them back in.
Do this for both amplifiers. The two short rack ears must be in opposite sides.
Mount the center connecting plate. Unscrew the four existent screws, attach the
connecting plate and screw them back in (D) as shown in the illustration.
C
Once the connecting plate is attached to one amplifier, align the four holes in the side
of the amplifier with the four hooks (1) and slide the other amplifier until the two
amplifiers hook together (2). To prevent pushback of the amplifiers, screw in the
supplied M3 bolt (3) into the screw hole on the back of the amplifier as shown in the
illustration.
x2
Installation manual
V Series
D
Dynacord