Table of Contents
Advertisement
V Series
5.2.2
Line input RJ45
The line input RJ45 connection can be used for an input of four (V600:4) resp. two (V600:2)
audio channels via a single cable, or as audio output/through when the Euroblock inputs are
in use. This allows one set of inputs from the Euroblock connections to go to another
amplifier. The pin out is compatible with any AES72‑1E device.
–
The wiring of AES72-1E is below.
Caution!
Do not connect the line input RJ45 with Ethernet, CAN bus, Call station, or even PoE
!
powered ports!
Noise can occur which may damage speakers or the amplifier.
Refer to
–
Dynacord
Compatible with standard CAT5e or CAT6 wiring. It is recommended to use a quality
shielded STP cable for increased distances over 5 m to 25 m to reduce audio and signal
degradation by maintaining balanced signal.
Indicators, controls and settings, page 25
Installation manual
Installation | en
2024.01 | V03 | F.01U.402.248
33
Advertisement
Table of Contents
