Remote Transmitter Programming; 2-Vehicle Programming; Option Programming - CrimeStopper SecurLinc CS-2008PC Installation & Operating Instructions Manual

Advanced remote control alarm system

Hide thumbs

Table Of Contents

Table of Contents

1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3

hear (3) chirps.

2. Press the Program/Override Button for 5 seconds and you should hear 5 chirps and LED comes on solid.

3. Press #1 (LOCK) on the transmitter once, you should hear 1 chirp. Press Button #1 again, you should

hears 2 chirps and this will confirm Code-learning.

4. Repeat step #3 above to learn up to 4 remotes or Turn OFF Ignition to exit.

Note: This system will learn a total of 4 transmitters max.

DIAGRAM:

IGN

OFF

5 CHIRPS

STATUS LED

ON SOLID

2 VEHICLE CONTROL

Your CS-2008PC remote transmitter has the ability to control a second vehicle with a Crimestopper CS-

2008PC system installed.

•

Follow the programming steps above, but at step #3 Press Button #5 (side button) of your remote 2 times

first, then press Button #1 (one chirp), and press Button #1 again (2 chirps). Your remote should now be

programmed to operate a second vehicle. You can simply press button #5 (side button) on your remote 2

times before pressing any button 1-4 to control the second vehicle.

PROGRAMMABLE OPTIONS:

1. Turn the Ignition ON and press the Program/Override button 5 times. The siren will chirp 3 times indicating

you are in programming mode.

2. Within the next few seconds, press the Override/Program button [again] the number of times that

corresponds to the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!

(If you don't hear a chirp then system did not record that button press!)

3. When you get to the desired option number, press the appropriate button on the transmitter according to

the chart below. Turn Ignition off. See Below for Option numbers, descriptions, and values. (Button 1

gives a single chirp, Button 2 gives two chirps, and Button 3 gives three chirps.)

4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options,

check operation to see if the option(s) have changed.

SEE OPTION PROGRAMMING TABLE: NEXT PAGE