Fieldmann FZP 2000-E Manual page 14

EN 14
Cutting
Cutting trees
Decide about the direction in which the tree will fall, respecting
the wind direction, incline angle of the tree and location of the
branches, and consider all other factors before cutting.
The area around the tree must be clear, without obstacles, and
must enable a stable stance. The escape route must be passable.
Cut a wedge into one third of the tree's diameter on the side to
which the tree should fall. (see fi g. Cutting trees, point 1)
From the opposite direction perform a separation cut at a level
above the wedge cut. (see fi g. Cutting trees, point 2)
The tree will fall in the direction towards the wedge cut.
(see fi g. Cutting trees, point 3)
ATTENTION!
When cutting trees, inform other people in the area about the potential danger. Cutting trees requires
experience and we do not recommend performing this task without the necessary experience.
Cutting logs
ATTENTION!
Always maintain a stable stance. Do not step on logs.
ATTENTION!
Before starting work, check that all components are in their place and that all nuts and bolts are tightened.
The log being cut may roll away. Especially when cutting on a slope, always stand above the log being cut.
Prevent kickback of the saw by following the instructions in chapter "Safety instructions".
Before starting work, assess the direction of the force causing the cut trunk to bend. The fi nal cut needs to
always be done from the opposite side of where the bending force is acting to prevent the guide bar from
being clamped inside the cut.
Only carry the chain saw with the motor turned off and the guide bar protected by the protective cover.
Log lying on the ground
Cut it halfway through, then roll it over and complete the cut
from the other side.
Log above the ground
In part "A" make a cut from below to a third of the log and
then complete the cut from above. In part "B" make a cut
from above to a third of the log and then complete the cut
from below.
Cutting trees
FZP 2000-E