Advertisement
6.
Slide the sealing insert into the clawing clamp and slide the clamping claw into the
sealing nut.
Fingers
Sealing
Groove
Nut
7.
Connect the RJ-45 connector on the Ethernet cable into the Ethernet LAN port inside
the sealing assembly. and tighten the sealing nut on the access point.
Note
The next step powers on the access point by attaching the Ethernet cable to a port
on a PoE++ source device. Allied Telesis recommends not performing the step
until you have completed all of the installation procedures.
8.
Connect the other end of the Ethernet cable to a port on a PoE++ source device,
such as a PoE++ switch.
Attaching the Antennas to the Access Point
1.
Remove the blind caps covering the antenna connectors.
2.
Screw a surge protector to an antenna connector.
3.
Screw the nut onto the surge protector and install the metal washer and rubber
washer, in that order, on the surge protector.
Nut
Metal washer
Rubber washer
Note
You must install 5GHz antennas to 5GHz antenna connectors and 2.4GHz
antennas to 2.4GHz antenna connectors.
4.
Screw an antenna onto the surge protector and tighten the nut against the antenna
Sealing Insert
to secure the antenna.
Clamping Claw
5.
Repeat this procedure to install the remaining antennas.
Installation Orientation
The access point must be installed on a pole or wall with the front panel facing down.
Installing the Access Point on a Wall
1.
Hold the mounting base on the wall at the desired location for the access point and
mark the four mounting base holes with a pencil.
Note
The mounting base can be in a vertical or horizontal position.
c
4
Back Panel
Front Panel
2.
Pre-drill the marked locations on the wall.
3.
Install the provided wall anchors in the holes.
4.
Place the access point upside-down on a table or desk.
5.
Attach the mounting base to the bottom of the access point with the provided screws,
spring washers, and washers, using a Phillips-head screwdriver.
Correct Order of
Washers
Screw
(M6xP1.0 16mm)
Spring Washer
Washer
6.
Attach the access point to the wall with the provided screws.
Installing the Access Point on a Pole
Pole
straps
Pole-mount bracket
Using the U-bolts and
Pole Mount Bracket
5
Mounting
base
Using the Pole Straps
and Mounting Base
6
Advertisement
