Table of Contents
Advertisement
Available languages
Available languages
INSTALLATIoN
Preparations
10.2 Transport and handling
Material losses
!
Store and transport the appliance at temperatures be-
tween -20 °C to +60 °C.
Handling
f Undo the 4 screws from the non-returnable pallet.
f
f Tilt the appliance and wind the 4 adjustable feet into the
f
appliance.
f Lift the appliance off the pallet. For a better hold during
f
transport, use the recessed grips on the underside and rear
of the appliance.
If narrow doors or hallways hinder handling, you can separate
the upper and lower sections of the appliance as described in the
following chapters.
10.2.1 Removing / fitting the front casing
Removing the front casing
f Remove the screw at the top in the middle of the appliance.
f
f Unhook the front casing towards the top.
f
www.stiebel-eltron.com
f Detach the plug of the electronic assembly for operation
f
(AA01-X1.18) and the earth connection (XE03) on the heat
pump manager.
Fitting the front casing
Fit the front casing in reverse order.
10.2.2 Separating / joining the appliance sections
Separating the appliance sections
f Pull the "heating sensor" out of the buffer cylinder.
f
XE03
AA01-X1.18
HSBC |
37
Advertisement
Chapters
Table of Contents
