Names And Functions - Kawai MP9500 Owner's Manual

1. NAMES AND FUNCTIONS
FRONT PANEL
[FADER SECTION]
1. VOLUME Fader
The VOLUME fader controls the master volume level of ihe MP9500. (Note:
The VOLUME fader does not affect the Fixed Qutputs on the rear panel.)
2. ZONE SELECT buttons
The ZONE SELECT buttons are used to select one of the four zones for editing.
Only one zone can be selected at a time. The front panel setting represents
the current zone status.
3. ON/OFF buttons
The ON/OFF buttons are used to turn zones ON/OFF. When the button is lit,
the zone is active.
4. FADERS (zone volume level control)
Each fader controls the volume level of a designated zone. When multiple
zones are active, these faders can be used as an audio mixer.
A accodo
" BG tI
sere = >
EFFECT | EFXRATE EFXDEPTH REVTME REV DEPTH
TT RN
Ò Ò Ò Ò
0 _
O_O uooirv CUTOFF ATTACK DECAY RELEASE
005
dirpipiinii
Tittdettiig
vetiitisioe
ala
-0
[CONTROL KNOBS SECTION]
The four CONTROL
KNOBS are multi-function real time controllers.
The
different functions can be selected using the four buttons to the left side of the
CONTROL KNOBS.
When a function button is lit, that function is active.
Touching any of these knobs will instantly change the Display to the current
knob function and value.
5. EFFECT button
When this button is lit, the CONTROL KNOBS will adjust the REVERB time,
REVERB depth, EFX rate and EFX depth.
6. EQ button
When this button is lit, the CONTROL KNOBS will adjust the 4-band graphic
equalizer.
7. TONE MODIFY button
When this button is lit, the CONTROL KNOBS will adjust the CUTOFE, ATTACK,
DECAY and RELEASE Levels for the selected zone.
8. MIDI CC# button
When this button is lit, MIDI control changes are sent from the MP9500 to the
O
MIDI device specified by the selected zone.
& [WHEEL CONTROLLERS]
S 9. PITCH BEND
This control wheel smoothly bends the pitch Up or Down from its current
value.
i B 10. MODULATION
This control wheel controls the modulation (vibrato) de pth. Moving the wheel
forward increases the vibrato depth.
8