Table of Contents
Advertisement
1. NAMES AND FUNCTIONS
FRONT. PANEL.
[FADER SECTION]
1 VOLUME Fader
This fader controls the master volume level of the MP9000. (Note: The VOLUME
fader does not affect the Fixed Outputs on the rear panel)
2 SELECT buttons
SELECT buttons are to select one of the four zones for editing. These buttons work
exclusively, so only one zone can be selected at a time.
The front panel setting
represents the current zone status.
3 ON/OFF buttons
These buttons are used to turn zones ON/OFF. When the lamp is lit, the zone is
active.
4 FADERS (zone volume level control)
Each fader controls the volume level of a designated zone. When multiple zones
are active, these faders can be used as an audio mixer.
(FADER SECTION)
oe
[CONTROL KNOBS SECTION)
Ro we
MM
a
a
a
a
rc
H
;
VOLUME
@
©) VEE errect
OLS:
[CONTROL KNOBS SECTION]
These four CONTROL KNOBS are multi-function real time controllers.
A function
can be selected using the four buttons to the left side of the CONTROL
KNOBS.
When the lamp is lit, that function is active. Touching any of these knobs will
instantly change the Display to the current knob function and value.
5 EFFECT button
When this button is lit, the CONTROL KNOBS will adjust the REVERB time, REVERB
[WHEEL CONTROLLERS]
depth, EFX rate and EFX depth.
6 EQ button
When this button is lit, the CONTROL KNOBS are working as a 4-band graphic
equalizer.
7 TONE MODIFY button
When this button is lit, the CUTOFF, ATTACK, DECAY and RELEASE Levels for the
selected zone can be changed.
8 MIDI cc# button
When this button is lit, MIDI control changes are sent from the MP9000 to the MIDI
device specified by the selected zone.
(WHEEL CONTROLLERS]
9 PITCH BEND
This control wheel smoothly bends the pitch Up or Down from its current value.
10 MODULATION
Vibrato depth is controlled by this wheel.
Moving the wheel forward increases the
effect.
Advertisement
Table of Contents
