Changing Charging Socket Protection Cap - KTM Freeride E-XC 2019 Owner's Manual

17.8

Changing charging socket protection cap

Warning
Risk of injury There is a risk of electric shock when working on high-voltage components.
Work on high-voltage components requires special training, qualifications and tools.
–
Have all work that is not described and explained performed by trained KTM mechanics only.
–
Do not open the electric motor or the lithium-ion battery (KTM PowerPack).
Info
If the safety cord or seal ring is damaged or torn off, the charging socket protection cap must be replaced.
KTM POWERPACK, BATTERY CHARGER 17
–
Switch off the battery charger using switch
After several seconds, all LEDs on the battery charger go
out.
–
Disconnect the battery charger power plug from the mains con-
nection.
–
Disconnect the charging cable from the KTM PowerPack.
Guideline
Pull on the structured part of the connector. Do not pull on
C00769-11 the cable.
–
Check the seal on the charging socket protection cap.
» If the seal is dirty:
–
Clean the seal without using water or compressed air.
» If the seal is damaged or worn:
–
Change the seal.
–
Mount the charging socket protection cap.
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the protection cap. (
Main work
–
1
Remove charging socket protection cap.
Guideline
Do not loosen
–
Remove residual safety cord.
–
Remove screws
–
Take off the carry handle.
M00743-10
4
p. 43)
p. 69)
p. 107)
p. 71)
A
nut.
2
.
.
115