Measuring The Dimension Of The Rear Wheel Unloaded (Sx-E 5); Checking The Static Sag Of The Shock Absorber (Sx-E 5) - KTM SX-E 3 2023 Owner's Manual

11.7 Measuring the dimension of the rear wheel unloaded (SX‑E 5)
11.8 Checking the static sag of the shock absorber (SX‑E 5)
Info
Turn clockwise to increase the damping; turn counter-
clockwise to reduce damping when the shock absorber
rebounds.
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Measure the vertical distance between the rear axle and a fixed
point, such as a marking on the side cover.
–
Note the value as dimension
400988-10
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Measure dimension
–
Hold the motorcycle upright with aid of an assistant.
–
Measure the distance between rear axle and fixed point again.
–
Note the value as dimension
Info
The static sag is the difference between
measurements
–
Check the static sag.
Static sag
» If the static sag is less or more than the specified value:
–
Adjust the spring preload of the shock absorber.
( p. 34)
400989-10
SUSPENSION SETTING 11
p. 46)
A
.
p. 46)
A
of rear wheel unloaded. (
B
.
A B
and .
12 mm (0.47 in)
p. 33)
33