Installing A Cable Gland (Sp-Wp-Cm20); Powering The Ap - Zcom SP250 Instructions Manual

802.11ax Access Point User Manual

3.4. Installing a Cable Gland (SP-WP-CM20)

(1)Dismantle all the components of waterproof cable gland,
(2) Plug the cable in between of Rubber clamper.
(3) Insert rubber housing
(4) Insert the rubber housing back to connector body
(5) Tighten the connector nut.
(6) Recheck waterproof cable gland.

3.5. Powering the AP

Connect the PoE 48V, then it will power on.
Note: Please wait for 5-10 seconds while powering on.
58-150006-IQN_V1.0
Page 5