Status; Overview - Zcom SP250 Instructions Manual

Note: IP address of WLC needs to be assigned (ex. 192.168.1.228) while on operation.

4.2.2. Status

4.2.2.1. Overview

This page is used to provide an overview of the software settings and status of the AP. The following parameters are
available in this section:
Parameter
Hostname
Model
Firmware Version
Kernel Version
Local Time
Uptime
Load Average
The following parameters are available in this section:
Parameter
Total Available
Free
58-150006-IQN_V1.0
802.11ax Access Point
Displays the hostnames of active DHCP clients connected to the AP. DHCP stands for
Dynamic Host Configuration Protocol.
Displays the AP Model.
Displays the AP firmware version.
Displays the Linux kernel version.
Displays the local time in your area.
Displays the how long the AP is active.
Displays the average system load calculated over a given period of time of 1, 5 and 15
minutes.
Displays the total memory supported by the AP in kilobytes and percentage.
Displays the free memory on the AP in kilobytes and percentage.
Description
Description
User Manual
Page 8