Entering Autodial Records - Uniden 410 Owner's Manual

To manually enter a name and number into autodial,
1 .
Press .
2.
3.
4.
5.
Press the soft key under "
an autodial location (01-20).
6.
7.
If a number has not already been
programmed, "
the display. Use the keypad to enter the
autodial number, up to 16 digits.
and can be entered as well. If
FLASH
the number is entered incorrectly, press
the soft key under " " to move the cursor
left and the soft key under "
remove digits. Use the keypad to
re-enter the correct digits.
NOTE:
Include the outside line digit if one is needed to dial
out of the system.
8.
PROGRAMMING AUTODIAL

ENTERING AUTODIAL RECORDS

" to select
" will appear in
,
" to
9.
Use the keypad to enter the name, up
to 14 characters. Pressing a key once
will display the first letter on that key.
Pressing it repeatedly will cycle through
all the characters on the key.
NOTE:
Pressing the 1 key will add a space.
10.
When the desired letter appears in the
display, press the soft key under
" " to move the cursor to the
right.
11.
Repeat steps 8 and 9 until the name is
entered.
12.
,
13.
Repeat steps 4 through 11 to program
the remaining autodial numbers.
14.
Press
18
to exit.