Uniden 410 Owner's Manual page 42

DISPLAYED MESSAGE
ADDITIONAL INFORMATION
DISPLAYS
STATUS
Nothing stored in this autodial
location.
Sending a page.
Line 1 has been disconnected
and then reconnected, a
station has been added to the
system, the AC power has
been removed and then
reconnected, a power failure
occurred or a unit changed it's
station ID.
Line 1 has been disconnected.
Station has released privacy.
Station has restored privacy.
The scratch pad button has
been pressed.
Line 1 has been disconnected,
AC power was lost or this is
initial setup.
Can not intercom, page all or
transfer.
(cont.)
42
ACTION
Select another autodial
location or store an autodial
number. See pages 17-19,
under "PROGRAMMING
AUTODIAL."
See page 37 to send a page.
Perform a system update at
another station. See page 40
under "PERFORMING A
SYSTEM UPDATE."
Reconnect line 1. If display
still appears after the line is
reconnected, make sure line 1
is not in use when line 1 is
reconnected.
Privacy has been released on
this call.
Privacy has been restored on
this call.
Enter the number you want to
store and then press
again. See page 29.
Press the soft key under
" ." See page 12 under
"ASSIGNING A STATION
EXTENSION NUMBER."
The intended station is busy
or other stations may be using
the intercom or page
functions. Try again later. See
"INTERCOM & PAGING
OPERATION" on pages 35-37.
SCRATCH PAD