Verifying Station And Line Configuration; Verifying System Configuration; Installation Checklist - Uniden 410 Owner's Manual

VERIFYING STATION AND LINE CONFIGURATION

1.
Press . The LINE INDICATOR will light green and the speakerphone LED will light red.
LINE 1
2.
The station ID will appear in the display to indicate the station is in use.
3.
Dial the telephone number for line 2. The LINE INDICATOR for line 2 should flash red. If the
line indicator, for the line you called, does not flash, check to make sure lines are correctly
installed.
4.
Repeat step 2 and call the telephone numbers for line 3 and 4.
5.
If the indicators of the lines you called flashed, you have successfully installed this station!

VERIFYING SYSTEM CONFIGURATION

To verify that all stations are communicating,
1.
Press and hold
2.
" " and the station icons for all properly connected stations will appear in the Station
Status Display. It may take a moment for all the icons to appear.
3.
Check to see if all stations connected to line 1, appear in the display. If they did, the system is
successfully configured. If all the stations do not appear in the display, note the station(s) that
did not appear in the display. Go to the noted station and make sure the lines are connected
and in the correct line jacks.

INSTALLATION CHECKLIST

AC adapter is connected at stations
Line cords have been connected
Line 1 is common on all stations
All stations have been assigned an extension number
The time and date have been set at all stations
INITIAL SETUP
QUICK SETUP
.
PAGE ALL
(cont.)
11