Line Mode For Unanswered Calls; Set Line Mode - Uniden AT4801 User Manual

Answering system basic setup

Line mode for unanswered calls

Set Line mode

Use this feature to set each of the telephone lines to respond to unanswered
incoming calls in one of the four possible line modes, as shown in the chart below.
Incoming call - the called
line flashes and rings on
every extension
Call not answered -
Line mode becomes active
To select the line mode:
When the console is idle, press MENU
1.
2. Press or
3. Press or
All lines, then press
4. Press or
attendant, Announce only or No answer).
SELECT or or /SKIP to confirm. To exit without making changes,
5. Press
MENU/
press CANCEL or /REPEAT.
Line mode:
Gen MB only
Line mode:
Auto attendant
Line mode:
Announce only
Line mode:
No answer
to scroll to Line mode, then press
to select the desired line (Line 1, Line 2, Line 3 or Line 4) or
SELECT or /SKIP.
MENU/
to choose the desired line mode (Gen MB only, Auto
The caller is prompted to leave a message
in the general mailbox, which a person at
any deskset or handset can review.
The general mailbox stores incoming
messages, memos and call conversations
(see pages 83-85 for more information).
Caller can select an extension, leave a
message in the general mailbox or listen to
the user-recorded directory.
When the auto attendant directs a call to
an extension but it is not answered, the
auto attendant prompts the caller to leave a
message for that extension.
The answering system plays an
announcement only and then the call
is dropped. You can use the default
announcement or record your own
announcement.
The system does not respond to the
incoming call. The call rings until the caller
hangs up.
.
/SELECT
MENU/
13
SELECT or /SKIP.