Chapter 2: Installing The S1 Chassis; Required Tools - Enterasys S Series Hardware Installation Manual

For information about...

Required Tools

Unpacking the S1 Chassis
Installation Site Requirements
Mounting the S1 Chassis
Unpacking the Power Supplies
Installing the Power Supplies
Powering Up the S1 Chassis
Removing and Installing a Fan Tray
Installing a Fabric Module and Connecting to the Network
Connecting to the COM Port for Local Management
Completing the Installation
Read the Release Notes specific to the firmware image running in the chassis to check for any
exceptions to the supported features and operation documented in this guide.
Required Tools
• ESD wrist strap (included with the S1 chassis)
• Phillips screwdriver
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Installing the S1 Chassis
Important Notice
Enterasys S-Series S1 Chassis Hardware Installation Guide 2-1
2
Refer to page...
2-1
2-2
2-3
2-3
2-5
2-5
2-7
2-9
2-10
2-10
2-12