Danfoss DEVI DEVIreg Touch Installation Manual page 18

If you break the small plastic seal
on the back of the display mod-
ule, e.g. using a screwdriver, it will
be possible to set the maximum
floor temperature up to 45°C.
Furthermore, it will be possible to
use only a room sensor. However,
this option is not recommendable due to an increased risk
of overheating the floor.
Important: When the thermostat is used to control a floor
heating element in connection with a wooden floor or
similar material, always use a floor sensor and never set the
maximum floor temperature to more than 35°C.
Note: Please contact the floor supplier before changing the
maximum floor temperature and be aware of the following:
• The floor temperature is measured where the sensor
is placed.
• The temperature of the bottom of a wooden floor can
be up to 10 degrees higher than the top.
• Floor manufactures often specify the max. tempera-
ture on the top surface of the floor.
18
DEVIreg™ Touch
Installation Guide