Sony SVO-9620 Manual page 28

Sensor Recording (Continued)
Lé-1
4-1 8(E) | Chapter 4 Recording
9 Set the TIMER switch to REC.
The SENSOR REC lamp on the indicator block will light and the VTR
automatically enters standby mode for sensor recording.
When a video signal is input through the rear panel connectors set in step 3,
the VTR automatically starts recording.
When the video signal is no longer input, the VTR automatically stops
recording and returns to the standby mode for sensor recording. The SENSOR
REC lamp on the indicator block remains lit.
To stop sensor recording
Press the STOP button.
© During sensor recording all the tape transport controls, except the STOP button,
are disabled. Also, immediately after the power is turned on, the STOP button is
temporarily disabled.
® After sensor recording has been completed, set the TIMER switch to OFF.
® At the tape end, the VTR automatically enters the operating mode set with the
menu. For example, if "tPE-Et" has been set, the VTR automatically ejects the
cassette at tape end.
©The VTR cannot enter the sensor recording mode and the SENSOR REC lamp
flashes in the following cases:
— When no cassette is inserted
— When you insert a cassette from which the safety tab has been removed
— When you insert a cassette in which the tape is already at tape end