Control switch
▫
for precise direct control by button valves
▫
for indirect control by push button valves
▫
control hose with integrated stress-relief rope
Disengaging clutch (as option)
▫
Not available for 125 kg capacity.
▫
For pulling out the uncharged wire rope.
▫
Disengagement operated by hand.
Unintended disengagement or disengagement by standard force effort is not possible under load.
4.4.1
Emergency brake release - hoist (option)
Manual emergency brake release for
lowering the load in case of power
supply failure by means of lever (A).
Pressure roller (as option)
The pressure roller prevents the skipping of rope
windings, when the unloaded rope will on- or
unwinded.
The
respective
rope
functionally correct .
DANGER!
The following is not allowed:
Disengaging under load.
Manipulation of the disengaging device.
Maintenance unit
It serves for the necessary preparation of the operation air so that the pneumatic motor can work troublefree.
If not assembled by the manufacturer, it must be assembled by the customer.
CAUTION!
Should the unit be assembled at the customer, the maintenance unit is supplied without oil.
Before putting the unit into operation, the main air supply line must be cleaned and the oiler of the
maintenance unit must be filled with oil. Should this not be done the unit may be severely damaged.
Special Parts
For use in explosion dangerous areas, are be installed some special units, special treated surfaces or made
in special material.
5.52.289.01.01.04
Electric
Illustrattion. 3
layers
will
pressed
Electric-EX
A
Illustration 4
Pneumatic + EX
13