Table of Contents
Advertisement
6.3 Shoulder strap adjustment
Before commencing work, adjust the shoulder
strap and handle according to the operator's body
size.
Wear the single shoulder strap over the opposite
shoulder to the side on which you are carrying the
power tool. Once the length of the strap has been
correctly adjusted the strap hook should be over
your hip. Hook the strap hook into the strap
attachment on the power tool.
Balance the power tool with fitted changeover tool
so that the cutter hovers just above the ground,
without you touching the power tool with your
hands.
If the tool hovers more than 30 cm above the
ground, the strap holder needs to be secured
nearer to the motor.
If the tool is touching the floor, the strap holder
needs to be secured nearer to the loop handle.
7. Fuelling
7.1 Fuel information
A high performance two-stroke engine
operated with a petrol:oil mixture (petrol + oil
= fuel mixture) or with a special fuel mixture for
two-stroke engines available from specialists
powers this machine.
We recommend the proprietary "Aspen 2-takt"
special fuel mixture. Please observe the special
fuel manufacturer's instructions.
Information on individual mixing of the fuel mixture
Normal or super unleaded petrol can be used for
individual mixing purposes (minimum octane
number 92 RON).
When using a particularly high quality proprietary
2-stroke engine oil such as the "SOLO Profi 2T-
Motoröl" which we supply, we recommend an
oil:petrol mixing ratio of 1:50 (2%).
When using other brands of 2-stroke oil we
recommend a mixing ratio of 1:25 (4%).
Only use proprietary 2-stroke engine oil!
Never store fuel mixture longer than 3 - 4 weeks.
Preparing the equipment for use; Fuelling
Fuel mixture table
Petrol in
litres
SOLO 2T
engine oil
2% (50 : 1)
1
0.020
5
0.100
10
0.200
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Avoid direct skin contact with petrol and
avoid inhaling petrol fumes - health hazard!
7.2 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off.
Carefully clean the area around the filler inlet.
Place the machine with the fuel inlet pointing
upwards. Unscrew the tank lid and fill the fuel
mixture up to the lower edge of the filler neck. Use
a funnel with filter to prevent tank contamination.
After filling the tank replace the tank lid and tighten
firmly.
Oil in litres
Other two-
stroke oils
4% (25 : 1)
0.040
0.200
0.400
ENGLISH 11
Advertisement
Table of Contents
