Table of Contents
Advertisement
Preparing the equipment for use
6. Preparing the equipment for use
For shipping purposes, the power tool is partly
disassembled and has to be reassembled prior to
use.
Only use the power tool after it has been fully
assembled.
Ensure that the tank is fully drained before any
assembly, disassembly or modification.
6.1 Assembly of the Loop-handle
Attach the "loop" handle approximately 5 cm - 30
cm from the strap attachment according to your
preferred working position. The longer side of the
handle serves as a safety barrier and must
therefore always be on the side of the user:
• If you carry the power tool on the right hand
side of your body when working then the longer
side of the handle must face to the left.
• If, however, you prefer to carry the power tool
on the left hand side of your body when working
(i.e. if you are left-handed) then the longer side
of the handle must face to the right.
Fig. 2
• Initially tighten the screws only lightly.
• Push the handle, in accordance with your body
size, into its optimum position.
• Then tighten the screws.
ENGLISH 10
6.2 Fitting the changeover tool
Fig. 3
• Undo tension screw (1).
• Release fixing pin (2) by pulling it out and
turning it.
• Fit the shaft sections precisely onto the
inner/outer quadrant of the shafts.
Ensure that the hollow shaft in the lower shaft
section mates with the quadrant in the upper
section of the drive shaft. When assembling it
may be necessary to lightly twist the lower shaft
tube to and fro.
• Release the fixing pin by turning and audibly
click into position in the shaft tube hole.
• Thoroughly tighten clamping screws.
To separate the shaft sections:
Fig. 4
• Release the straining screw (1).
• Pull out the fixing pin (2).
• Pull the lower shaft tube (3) with gearbox from
the female coupling.
Advertisement
Table of Contents
