Table of Contents
Advertisement
5.15
5.15.1
5.15.2
5.15.3
5.15.4
SPINDLE ASSEMBLY
Remove the Logic PCBA (see Section 5.2)
.
Remove the Cone Lever Assembly (see Section 5.4)
.
Remove the drive belt (see Section 5.1 ).
Lay the disk drive on its
side.
5.15.5
With a Phillips
screwdriver,
while holding the
hub,
remove the mounting screw and washer from the
Spindle Assembly (see Figure 5-30).
5.15.6
Remove the
large
pulley from the bottom of the chassis (see Figure 5-30).
i
MOUNTING SCREW
~ @
FLAT WASHER~-:...-::...--::..-=..-:::._-
Figure 5-30
Spindle Assembly Mounting
Screw,
Washer,
and Pulley
5.15.7
Using one-quarter
(1
/4)
inch
wrench,
loosen
the two (2) hex head screws that attach the Spindle As-
sembly to the top of the chassis
(see
Figure 5-31
).
5.15.8
Rotate the retainer counterclockwise until
its
slot openings no longer are held by the two (2) hex head
screws
(see
Figure 5-31
).
5.15.9
Remove the Spindle Assembly by pulling
it
up and away from the chassis.
5.15 .10
Insert the new Spindle Assembly carefully into its mounting
hole
at the top of the chassis (see Figure
5-31
).
5-34
Advertisement
Table of Contents
