NOTE
Take care not to enlarge the hole in the chassis.
5.8.7
Press in the new guide rail evenly.
5.8.8
Push down on the front panel until it
is
back in
place.
5.8.9
After turning the disk drive upside down, reinstall the two (2) mounting screws located near the front of
the chassis with a Phillips
screwdriver.
5.8.10
After turning the disk drive right-side up, put the bushing over the front panel locating tab.
5.8.11
Put a small drop of glue (Permabond, Superglue, or other cyanoacrilic adhesive) on top of the front
panel locating tab.
5.8.12
5.8.13
If the right-hand guide rail has been replaced, reloop the head cables over the two (2) guide rail posts.
Reinstall the Logic PCBA (see Section 5.2).
5.8.14
If the left-hand guide rail has been replaced
,
verify the Write Protect Switch and its adjustment (see
Section 5.12.14)
.
5.8.15
Reinstall the Logic PCBA (see Section 5.2).
5-18