5.5.4
Put the cone shaft
through
the cone.
5.5.5
Slip on
the
release spring
,
the
expander,
the upper bearing, the step washer, the cone spring, and the
spring washer.
5.5.6
5.5.7
5-8).
5.5.8
5.5.9
5.5.10
NOTE
Ensure that the bearing is fully seated
in
the expander.
Compress
the
spring
,
and put the cone shaft
through
the hole in the Cone Lever
Assembly.
Install the
three (3)
washers and the E-ring in order to retain the Cone Lever Assembly (see Figure
Reinstall
the
Cone Lever Assembly
(see
Section 5.4.12).
Make the required checks
(see
Section 5.4.21
).
Reinstall the
Logic PCBA
(see
Section 5.2).
5-11