STEPPER
MOTOR CABLES
.:m.:;~~~~-MOUNTING
MOUNTING SCREW
Figure 5-5
Cone Lever Assembly Harnessing, Mounting, and Stepper Motor Cables
SCREW
CABLE
HARNESSES (Z)
5.4.9
Slide the Cone Lever Assembly rearward to release the upper arm finger (see Figure 5-5).
5.4.10
Remove the Cone Lever Assembly by lifting it up and toward the rear of the disk drive, and sliding the
front door out of its tracks.
5.4.11
Holding the new Cone Lever
Assembly,
put the front door into its
tracks,
and move it as far as it will go
toward the front of the disk drive. Then, carefully lower the cone lever, lifting the upper arm finger over the cone
lever.
5.4.12
With a Phillips screwdriver, install but do not tighten the two (2) mounting screws that attach the rear of
the Cone Lever Assembly to the chassis.
5.4.13
Reloop the two (2) head cables over the right rail in two (2)
places.
5.4.14
Using a Phillips screwdriver. install the mounting screw that attaches the index emitter holder to the
Cone Lever Assembly.
5.4.15
Harness the top index emitter cables to the Cone Lever Assembly (see Figure 5-6).
5-7