5.7.7
Taking the new front panel,place the front door
in
its tracks on the front panel, and place the new front
panel on the rail pins
(see
Figure 5-11 ).
5.7.8
After upending the disk
drive,
using a Phillips screwdriver, reinstall the two (2) mounting screws that
attach the front panel to the chassis
(see
Figure 5-13).
5.7.9
Push the Activity LED Assembly into its grommet.
NOTE
The Activity LED Assembly usually makes a clicking noise when it is
firmly pushed
into
the LED grommet.
5.7.10
5-12).
Push the Activity LED Assembly retaining collar over the back of the LED grommet (see Figure
5.7.11
Install two
(2)
new bushings on the right-hand and the left-hand front sides of the front panel (see
Figure 5-11 ).
5.7.12
Put a small drop of glue (Permabond, Superglue, or other cyanoacrylic adhesive) on top of each
bushing.
5.7.13
Reinstall the Logic PCBA (see Section 5.2).
5-16