Tandon TM-100-1 Operating And Service Manual page 64

NOTE
Be sure to align the holes in the Servo PCBA with the holes in the
spacers.
5.3.7
Using a Phillips screwdriver, attach the Servo PCBA to the chassis with the two (2) mounting screws.
NOTE
If nylon screws are used, ensure that they are installed at the same
location .
5.3.8 Plug Connectors P20 and P21 into their proper slots on the Servo PCBA- P20 on the top and P21 on
the bottom - see Figure 5-3.
5.3.9
5.3.10
Check the drive motor speed (see Section 2.1.1 ).
Check the Instantaneous Speed Variation (ISV) (see Section 2.1 .2).
5-5