Advertisement
REPLACING THE
1-;
CORRECTION TAPE
1
Remove the Ribbon Cassette by following steps
1 - 4 of " R E P L A C I N G T H E RIBBON CAS-
SETTE".
2
Remove the used Correction Tape by pulling the
Tape Spools outwards on both sides.
3
Place the new Correction Tape with the Full
Spool on the left side, and then pass the tape
between the Card Holder and the
Ribbon
Guides.
Ribbon Guides
Card Holder
•
Make sure that the inner surface of the tape on the
spool faces toward the Platen.
4
Turn the right spool clockwise until the white
tape appears at the center of the Card Holder.
5
Install the Ribbon Cassette properly. (Follow the
steps 5 through 8 of " R E P L A C I N G T H E RIB-
BON CASSETTE".)
Always set the POWER Switch to "OFF" before
exchanging the Correction Tape.
Do not touch the Carriage while the power is "ON".
Advertisement
Chapters
