Advertisement
Chapter
1
b .
How to Print Text
Functions Stored in the Text Memory
You can register the following functions. Each time a
function is registered, the corresponding symbol will
appear on the LCD Display.
•Bold
Printing
Q (start), jj] (end)
•Underlined
Printing
p- (start),
(end)
•Tab
~
•Paragraph
Indent
£ (start), J (end)
•Decimal
Tab
t
r
«
•Right
Margin Flush
^
•Margin
Centering
.i
(TAB centering cannot be registered.)
•If
you wish to enter Tabs or Decimal Tabs in a Text,
it is recommended that you store the Line Format to
avoid errors when the Text is printed.
Exiting from the Text Memory Mode
Press the TEXT IN/OUT Key
when text is not to be printed
in the Text Memory Mode.
The following message ap-
pears on the LCD Display and
you can exit from the Text
Memory Mode.
TEXT
IN/OUT
TEXT
IN/OUT
PRINT
ON/OFF
Set the line spacing.
When the line format is
not stored, set the mar-
gins, printing pitch and
carriage position.
•When
you wish to perform
justified printing of a text,
set the Operation Mode to
"JUST".
Press the TEXT IN/OUT
Key, enter the file name
corresponding to the file
whose contents are to be
printed and press the RE-
TURN Key.
Immediately after the de-
sired
file
has
been
selected, the cursor will
be located at the top of
the text.
To start printing from an
intermediate point in the
text, move the cursor to
the desired position.
Press the PRINT ON/OFF
Key.
Printing starts from the
cursor position.
TEXT PRINTING
TEXT MEMORV MODE END
PRINT
ON/OFF
A total of 30 files can be registered. If an attempt is
made to register more than this number of files, the
following message will appear on the LCD Display.
To stop printing tempo-
rarily, press the PRINT
ON/OFF Key again.
Printing then stops at the
beginning of the next line.
•The
PRINT ON/OFF Key is
used to start, temporarily
halt and resume printing.
•After
temporarily stopping
printing, you can type addi-
tional words on the paper
but these words will not be
stored in the Text Memory.
TOO MANY FILES
liFI
Advertisement
Chapters
