Appendix C - Manufacturer's Emc Declarations - MAGSTIM 2002 Operating Manual

Magstim 200 2
Operating Manual
APPENDIX C - MANUFACTURER'S EMC DECLARATIONS
Guidance and Manufacturer's Declaration - Electromagnetic Emissions
The Magstim 200
2
is intended for use in the electromagnetic environment specified below. The customer or the user of the equipment
should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic environment - guidance
RF emissions Group 1 The Magstim 200
2
must emit electromagnetic energy in order to perform its intended
EN55011 function. Nearby electronic equipment may be affected.
RF emissions Class B The Magstim 200
2
is suitable for use in all establishments other than domestic and those
EN55011
directly connected to the public low-voltage power supply network that supplies buildings
used for domestic purposes.
Class B
Harmonic Emissions (by equipment
IEC 61000-3-2 type)
Voltage fluctuations/
flicker emissions Complies
IEC 61000-3-3
Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The Magstim 200
2
is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer
or the user of the Magstim 200· can help prevent electromagnetic interference by maintaining a minimum distance between portable and
mobile RF communications equipment (transmitters) and the Magstim 200
2
as recommended below, according to the maximum output
power of the communications.
Rated maximum output Separation distance according to frequency of transmitter
power of transmitter m
w
150 kHz to 80 MHz 80 MHz to 800 MHz
800 MHz to 2,5 GHz
3,5
- -
3,5
- -
7
- -
d=[--J,v
p d=r--H
P
d=[--J·J
p
v,
E1 E1
Where
Vi=
3
Where E,
=
3 Where E,
=
3
0,01 0,117 0, 117
0,233
0,1 0,369 0,369 0,738
1 1,167 1,167 2,333
10 3,689 3,689 7,379
100
11,667
11,667 23.333
For transmitters rated at a maximum output power not listed above, the recommended separation distance din metres (m) can be
estimated using the equation applicable to the frequency of the transmitter, where Pis the maximum output power rating of the transmitter
in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
© The Magstim Company Limited 20 MOP01-EN-01