Battery Placement After Complete Device Disassembling; 2X6 Socket Pinout; Pc Connection (Windows) - Teltonika FMB125 First Start-Up Quick Start Manual

Battery placement after complete device disassembling

1. Using double sided tape, stick internal battery to the bottom part of the device case. Battery
should be glued approximately 15 millimeters from the bottom wall of the case. Picture on the
left.
2. Connect battery to the PCB.
3. Gently place PCB into the bottom case.

2x6 socket pinout

PIN
PIN NAME
NUMBER
1 VCC (10-30)V
DC (+)
2 AIN 1
3 RS232-RX
4 RS232-TX
5 DIN 1
6 INPUT 6
7 GND (-)
8 DOUT 1
9 RS485-A
10 RS485-B
11 1WIRE DATA
12 INPUT 5

PC Connection (Windows)

Power-up FMB125 with DC voltage 10-30 V power supply using supplied power cable.
1.
LED's should start blinking, see
DESCRIPTION
Power supply (+10-30 V
DC).
Analog input, channel 1.
Input range: 0-30 V DC.
Input for data reception
through RS-232.
Output for data
transmission through
RS-232.
Digital input, channel 1.
TX EXT (LVCAN – TX).
Ground.
Digital output, channel 1.
Open collector output.
Max. 3,3 A DC.
Signal wire A for RS-485.
Signal wire B for RS-485.
Data for 1–Wire devices.
RX EXT (LVCAN - RX).
"FMB125 LED status".