Battery Placement After Complete Device Disassembling; 2X6 Socket Pinout - Teltonika FMB122 First Start-Up Quick Start Manual

Battery placement after complete device disassembling

1. Using double sided tape, stick internal battery to the bottom part of the device case. Battery
should be glued approximately 15 millimeters from the bottom wall of the case. Picture on the
left.
2. Connect battery to the PCB.
3. Gently place PCB into the bottom case.

2x6 socket pinout

PIN
PIN NAME
NUMBER
1 VCC (10-30)V
DC (+)
2 AIN 1
3 AIN 2 / DIN 3
4 DIN 2
5 DIN 1
6 INPUT 6
7 GND (-)
8 DOUT 1
9 DOUT 2
10 1WIRE POWER +3,8 V output for 1–Wire
11 1WIRE DATA
12 INPUT 5
DESCRIPTION
Power supply (+10-30 V
DC).
Analog input, channel 1.
Input range: 0-30 V DC.
Analog input, channel 2.
Input range: 0-30 V DC /
Digital input, channel 3.
Digital input, channel 2.
Digital input, channel 1.
TX EXT (LVCAN – TX).
Ground.
Digital output, channel 1.
Open collector output.
Max. 3,3 A DC.
Digital output, channel 2.
Open collector output.
Max. 3,3 A DC.
devices.
Data for 1–Wire devices.
RX EXT (LVCAN - RX).