Advertisement
How to insert Micro-SIM card and connect battery
1.You will receive your device partly closed.
2.Gently remove top and bottom covers.
3.Insert SIM card as shown with PIN request disabled or read our Wiki how to enter it later in
Teltonika Configurator. Make sure that SIM card cut-off corner is pointing outward from slot. SIM
slot 1 is closer to PCB, SIM slot 2 is the top one.
4.Connect battery as shown to device. Position the battery in place where it does not obstruct other
components.
5.After configuration, see "PC Connection (Windows)", attach device top and bottom cover back and
press them twice to the full closure.
6.Make sure that product casing is closed correctly.
This device has an IP67 casing with a two-phase closing, that ensures a reliable protection and
ease of use. Please make sure that product casing corner clips are fixed tightly and cable is
connected to the device in order to maintain the degree of IP67 protection.
Battery placement after complete device disassembling
1.
Using double sided tape, stick internal battery to the bottom part of the device case. Battery
should be glued approximately 15 millimeters from the bottom wall of the case. Picture on the
left.
2.
Connect battery to the PCB.
3.
Gently place PCB into the bottom case.
2x6 socket pinout
Advertisement
