How to insert Micro-SIM card
Gently remove FMM150 cover using plastic pry tool from both sides.
1.
2.
Insert Micro-SIM card as shown with PIN request disabled or read
enter it later in Configurator. Make sure that Micro-SIM card cut-off corner is pointing
forward to slot.
Attach device cover back.
3.
4.
Device is ready to be connected.
Micro-SIM card insertion/removal must be performed when device is powered off –
external voltage and internal battery disconnected. Otherwise Micro-SIM card might be
damaged or device will not detect it.
Battery placement after complete device disassembling
1.
Using double sided tape, stick internal battery to the bottom part of the device case. Battery
should be glued approximately 15 millimeters from the bottom wall of the case. Picture on the
left.
2.
Connect battery to the PCB.
3.
Gently place PCB into the bottom case.
2x6 socket pinout
Security info
how to