VeriFone P630 Installation Manual page 35

Failure to use this decommission procedure causes non-compliance to the PCI Failure to use this decommission procedure causes non-compliance to the PCI
PTS POI Modular Security Requirements version 6.0 approval of the device. PTS POI Modular Security Requirements version 6.0 approval of the device.
To securely decommission the device: To securely decommission the device:
1 1
Prepare your tool — a #8 Phillips head screwdriver is necessary. Prepare your tool — a #8 Phillips head screwdriver is necessary.
2 2
Ensure that the device is disconnected from power and any other cables. Ensure that the device is disconnected from power and any other cables.
3 3
Turn the device face down, exposing the rear of the device. Turn the device face down, exposing the rear of the device.
4 4
Using the Phillips head screwdriver, remove each of the eight screws. Four of Using the Phillips head screwdriver, remove each of the eight screws. Four of
the screws are covered by the rear cable cover. You must remove the cable the screws are covered by the rear cable cover. You must remove the cable
cover to access these screws. cover to access these screws.
One screw is covered by a tamper-evident security label. Push the screwdriver One screw is covered by a tamper-evident security label. Push the screwdriver
through this label to access the screw. through this label to access the screw.
5 5
Once all the identified screws have been removed, carefully separate the top Once all the identified screws have been removed, carefully separate the top
housing plastics from the bottom 1mm, then pinch the top and bottom housing housing plastics from the bottom 1mm, then pinch the top and bottom housing
back together ensuring a proper fit. back together ensuring a proper fit.
6 6
Reinsert all the screws previously removed. Tighten each screw completely. Reinsert all the screws previously removed. Tighten each screw completely.
7 7
Insert the power cable and power up the device. Insert the power cable and power up the device.
8 8
Turn the device face up showing the display and keypad. Verify that the unit is Turn the device face up showing the display and keypad. Verify that the unit is
in an "Active Tamper." You should see the *TAMPER* message displayed on in an "Active Tamper." You should see the *TAMPER* message displayed on
the screen. the screen.
Installation Guide P630
35
© VeriFone, Inc. All rights reserved.