Ventilation Duct Connection And Insulation; Installation And Configuration Of Accessories; Electrical Connections; Main Circuit Board Layout - SystemAir SAVE VTC 200-1 Installation Instructions Manual

The drainage on the supply air side are mounted with an end cap at delivery.
In summer periods, when the outdoor air has a high humidity and the indoor
air is cool, condensation can occur on the supply air side. Remove the end
cap and connect a hose (available as an accessory).
The height (H) must be at least 60 mm.
6.2

Ventilation Duct Connection and Insulation

Important
• Always cover the ventilation ducts during construction period.
• Make sure there are no loose objects or impurities inside the ducts.
Install the ducts, supply air diffusers and air intake grilles as shown in the ventilation drawing.
• Supply air and extract air ducts must be insulated if located in cold places.
• Outdoor air and exhaust air ducts with cold air must be insulated if located in warm places (inside building's vapour
barrier).
It is very important to insulate cold ducts and joints tightly without any gaps, otherwise there is a risk of condensation
which may result in moisture damage.
Do not install the ducts directly against structural building elements to avoid sound propagation. Use acoustic insulation
and sound attenuators.
Note:
The type of ventilation ducts and insulation differ for each building and climate zone. If the ventilation
drawing is not provided, please contact your installer or place of purchase for recommendations.
6.3

Installation and Configuration of Accessories

Please follow instructions included with the accessory or consult "Service and Accessories Installation" manual which
can be found in our online catalogue.
7

Electrical connections

7.1

Main circuit board layout

The SAVE VTC 200 – 1 is equipped with built-in regulation and internal wiring.
398085 | v01
Electrical connections |
9