Table of Contents
Advertisement
7. PRECAUTIONS
DURING OPERATION
a
WARNING: For reasons of safety, always follow
these safety precautions.
When
raising the machine,
if the rope is not fixed properly, the machine may slip and cause a serious accident or
injury.
1.
The weight table given below shows the weights of the machine manufactured by Komatsu when it is shipped
from the factory.
Weight
Without
Blade
With
Blade
Maximum
D32E-1
D32P-1
6746 kg
7340 kg
(14842 lb)
(16149 lb)
7133 kg
7782 kg
(15725 lb)
(17155 lb)
D38E-1
7250 kg
(15951 lb)
7675 kg
(16885 lb)
8437 kg
(18600 lb)
8664 kg
(19400 lb)
8755 kg
(19300 lb)
D38P-1
7554 kg
(16619 lb)
8011 kg
(17625 lb)
9072 kg
(20000 lb)
D39E-1
7983 kg
(17562 lb)
8466 kg
(18625 lb)
D39P-1
8133 kg
(17892 lb)
8643 kg
(19015 lb)
9798 kg
(21600 lb)
10000 kg
(22000 lb)
2.
Always apply the parking brake before fitting a sling or wire rope.
3.
Always use a sling or rope of suitable strength when raising the machine.
4.
Use protectors at sharp corners or places where the wire or cable will bite in. Position the crane so that the
machine is raised horizontally. Make the width of the sledder and bar wide enough so that it does not contact
the machine.
5.
Method of fitting rope.
Pass cable under the undercover
and the steering case
Lifting points
6.
Check safety:
After fitting the rope, raise the machine 100 to 200 mm (4 to 8 in) and check that there is no slack in the
wire cable and that the machine is being raised horizontally.
7.
If any points are unclear, please contact your Komatsu distributor for advice.
1-12
Advertisement
Table of Contents
