Komatsu D32E-1 Operation & Maintenance Manual page 155

24. SERVICE PROCEDURE
24.10.3 DRAIN FUEL TANK SEDIMENT BOWL
Open the valve and drain water and sediment from the fuel tank until clean
diesel fuel appears. Close the valve.
24.10.4 REPLACE IN-LINE FUEL STRAINER
1.
2.
3.
Close the shut off valve under the fuel tank.
Loosen the clamps holding the hose to the strainer at both ends and remove
the strainer.
Install the new strainer with the arrow pointing in the direction of flow (away
from the fuel tank). Open the fuel shut off valve.
24.10.5 LUBRICATE
24.10.5.1 MOUNTED EQUIPMENT CONTROLS
REMARK
Five fittings without a ripper or six fittings with a ripper.
Apply grease until clean lubricant is visible. Always use a clean lubricator and
wipe dirt from fittings before fresh grease is applied. If grease fails to go through
the fitting, determine the cause and correct it. After greasing, wipe off any old
grease that was purged.
24.1052 LEFT AND RIGHT FOOT PEDALS
Apply grease until clean lubricant is visible. Always use a clean lubricator and
wipe dirt from fittings before fresh grease is applied. If grease fails to go through
the fitting, determine the cause and correct it. After greasing, wipe off any old
grease that was purged.
3-54